1. … Welding procedure (including preheat temperature, interpass temperature and PWHT) will be dependent on … flux even in narrow gabs. To obtain optimum mechanical properties the heat input should be kept below 15 kJ/cm and interpass temperature …
  2. … be used for a working temperature of up to 450ºC. The recommended preheat temperature is 200ºC - 300°C unless the base material requires a higher preheat temperature. Use DC+ polarity and min 2 layers are required. A …
  3. … dissimilar welding between cast iron and high alloyed stainless and heat resistant steels or mild steels. Excellent Weldabillity with … and high resistance against porosity. The weld metal is corrosion and heat resistant. Very well suitable for welding with robotics or …
  4. … for fabrication and repair welding on equal or similar, corrosion and heat-resistant steels and steel-castings. The weld-deposit is on equal … at higher temperatures up to 1150 °C. When welding CEWELD 4820 AC low heat-input is required as alloys of such chemistry are sensitive to …
  5. … of 890N/mm2. To obtain the requested mechanical properties the heat input should be kept around 10 KJ/cm. Cooling time (T8/5) must be adjusted by travel speed and preheat temperature. … S890 TM-pipe steels to StE 890 to S890QL1, A 517, X …
  6. … the pure aluminium grades. Heavy parts and thicker plates should be preheated (150°C), prior to welding. At the same time, it keeps the … and workability. It can be strengthened by cold working, but not by heat treatment. … Al99,0 Al.99,5 Al.99,7 E-Al., 99,5, 3.0205, 3.0255, …
  7. … For welding heat-resistant austenitic steels of the 25% Cr, 20% Ni types. CEWELD … oxidation depend on cycle frequency. In general the alloy is heat resistant up to 1200 °C. This alloy can withstand relatively …
  8. … Machinable ,Heat resistant weld deposit with excelent wear resistance. The weld deposit can be heat treated to offer maximum service protection.  Tempered 560° C ~ 52 …
  9. … spatter free welding with very low current. Due to the very low heat input and unique composition of CEWELD E Ni(-) the transition zone … case off multi-layer welding. The weld metal will show no undercut !Preheating is normally done to slow down the cooling speed, in case you …
  10. … bright, almost smut-free welds. Not recommended for anodizing. Non-heat treatable. Thicker sections should be preheated (150°C) prior to welding. … AlMgSi 0, AlSiMg (A), AlSi 1 MgMn, …