1. … for fabrication and repair welding on equal or similar, corrosion and heat-resistant steels and steel-castings. The weld-deposit is on equal … at higher temperatures up to 1150 °C. When welding CEWELD 4820 AC low heat-input is required as alloys of such chemistry are sensitive to …
  2. … the pure aluminium grades. Heavy parts and thicker plates should be preheated (150°C), prior to welding. At the same time, it keeps the … and workability. It can be strengthened by cold working, but not by heat treatment. … Al99,0 Al.99,5 Al.99,7 E-Al., 99,5, 3.0205, 3.0255, …
  3. … Machinable ,Heat resistant weld deposit with excelent wear resistance. The weld deposit can be heat treated to offer maximum service protection.  Tempered 560° C ~ 52 …
  4. … For welding heat-resistant austenitic steels of the 25% Cr, 20% Ni types. CEWELD … oxidation depend on cycle frequency. In general the alloy is heat resistant up to 1200 °C. This alloy can withstand relatively …
  5. … dissimilar welding between cast iron and high alloyed stainless and heat resistant steels or mild steels. Excellent Weldabillity with … and high resistance against porosity. The weld metal is corrosion and heat resistant. Very well suitable for welding with robotics or …
  6. … spatter free welding with very low current. Due to the very low heat input and unique composition of CEWELD E Ni(-) the transition zone … case off multi-layer welding. The weld metal will show no undercut !Preheating is normally done to slow down the cooling speed, in case you …
  7. … bright, almost smut-free welds. Not recommended for anodizing. Non-heat treatable. Thicker sections should be preheated (150°C) prior to welding. … AlMgSi 0, AlSiMg (A), AlSi 1 MgMn, …
  8. … of improvements, such as: weldable with very low current, non overheating coating and a powerful arc at very low amps. The deposit is … from porosity even on old and or otherwise diluted base material. Preheating is normally done to slow down the cooling speed, in case you …
  9. … may be used in applications at sustained elevated temperatures. Non-heat treatable. Thicker sections should be preheated (150°C) prior to welding. … G-AlSi10Mg, G-AlSi11, G-AlSi12 (Cu), …
  10. … 15CrMoV6 provides  high  strength, actual strength being dependent on heat treatment  Preheat,  interpass  temperature and PWHT will  be dependent  on …