1. CEWELD® AA R690 was one of “The first seamless rutile FCW with extreme low hydrogen for S690” Excellent for use in positional welding where high deposition rate is required, suitable for temperatures down to -60 ºC ( with offshore Approval down to -40°C). Excellent for use on ceramic backing and …
  2. … deposit is capable of taking a high polish.Structure: Austenite with delta ferrite … ISO 15608: 8.1 / TüV Groupe 29 (+22+21) / E347, 19 9 …
  3. … mechanical properties the heat input should be kept around 10 KJ/cm. Cooling time (T8/5) must be adjusted by travel speed and preheat … grain structural steels (low temp) to StE 960 (StE 1100 to 12 mm) to S960QL1 (S1100 to 12 mm) … SA 890 … 26304-A: S4Ni2CrMo …
  4. … The Advantages of the WearPlate Pro 6072 wear system: 10 times faster than overlay welding by SMAW. No dilution with the … heat that effects the basemetal or cause loose in strength two times faster to apply compare to big overlay welded plates 50% weight …
  5. … will show no undercut !Preheating is normally done to slow down the cooling speed, in case you can not control the cooling speed it is better to keep the work peace at a low temperature …
  6. … arc at very low amps. Preheating is normally done to slow down the cooling speed, in case you can not control the cooling speed it is better to keep the work peace at a low temperature …
  7. … arc at very low amps. Preheating is normally done to slow down the cooling speed, in case you can not control the cooling speed it is better to keep the work peace at a low temperature …
  8. … will show no undercut !Preheating is normally done to slow down the cooling speed, in case you can not control the cooling speed it is better to keep the work peace at a low temperature … … Grey Cast Iron, Malleable cast iron, EN 1561: EN-GJL-100 (GG10) till EN-GJL-350 (GG35), EN 1562: EN-GJMB-350 (GTS 35) till EN-GJMB-550 …
  9. … high Tungsten content the wear resistance against abrasion is 4 till 8 times better in comparison with C-Cr alloys … Sinter plant …
  10. … diluted base material. Preheating is normally done to slow down the cooling speed, in case you can not control the cooling speed it is better to keep the work peace at a low temperature …